Hoover S3592 Manual - Page 7

3-8 G Filters - secondary and final How to clean Turn cleaner off and disconnect from electrical outlet. The secondary filter (G), located at the rear of the filter bag compartment, protects the motor from dirt particles. If the filter becomes dirty, lift filter out. Wash filter in warm water. Allow to air dry completely before returning filter to cleaner. Do not operate cleaner without secondary filter in place. 3-10 3-9 J H I Turn cleaner off and disconnect from electrical outlet. The final filter, located on the back of the cleaner body, aids in the filtration process to return clean air to the room. To remove this filter, use thumb to open and pull down on filter door (H). Lift filter out and wash in warm water. Allow to air dry completely before replacing filter. Return filter to the inside of the filter door. Replace filter door by aligning tab (I) on door with slot (J) on cleaner body. Rotate door upwards, pressing to snap into place. Belt replacement The belt in your power nozzle drives the agitator. It has been designed specifically for use in this cleaner and is important for effective operation. What to buy There are other belts manufactured that are similar in shape and size, but are not designed for the HOOVER Duros™ power nozzle. Such belts do not operate the agitator correctly and may create stress which could damage your power nozzle. Use only a genuine HOOVER belt package no. 40201270 (part no. 59134226) when a belt replacement is necessary. When to replace The belt should be checked from time to time to be sure it is in good condition. To check, remove the nozzle cover (see following section). Replace the belt if it is stretched, cut, or broken. 3-11 B 3-12 A D C How to replace Turn cleaner off and disconnect from electrical outlet. Disconnect power nozzle from extension wands. To remove hood, turn nozzle over and unscrew the 2 recessed screws. Return nozzle to original position and lift off hood. 3-13 F E G If belt (E) is not broken, but is stretched or cut, pull it off the motor pulley (F). Lift up end of agitator brush roll (G). Remove old belt from agitator pulley and replace with new belt. Lettering on belt must be visible. Stretch belt back and attach to motor pulley. Rotate headlight assembly (A) away from the brush roll cover (B). 3-14 Hold opposite end of agitator brush roll in place. Push belt end forward, pushing down until fully seated in place. Turn agitator, making sure it rotates freely. C Unscrew four screws (C) located at rear of brush roll cover. Remove two metal brackets (D). Lift off brush roll cover. 3-15 I H B Replace brush roll cover (B) over agitator brush roll by aligning the two U-shaped slots in the brush roll cover (H) with the center screw housings (I). Press brush roll cover back into position. Continued ➠