Hotpoint RGBS200DMWW Use and Care Manual - Page 16
Cooktop, CARE AND CLEANING
View all Hotpoint RGBS200DMWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
CARE AND CLEANING: Cooktop Cooktop Removal of Surface Burners for Cleaning Turn all controls OFF. Allow cooktop to cool before removing grates and burner parts. When removing the burner caps and heads, remember their size and location. Replace them in the same location after cleaning. Round Burner Cap 5HPRYDEOH Round Burner Head Electrode Round Burner (on some models) Cleaning the Surface Burners Cleaning the Burner Caps Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles. The round burner caps may also be cleaned in your dishwasher. Cleaning the Burner Heads Wash the burner heads routinely, especially after bad spillovers which could clog the burner openings. Lift burners off when cool. Wash with hot, soapy water. Rinse with clean water. For more stubborn stains, use a brush with plastic bristles. NOTE: Do not use steel wool or scouring pads to clean the burner parts as these may clog the openings. Never wash burner heads in your dishwasher as dishwasher. Doing so may cause them to discolor. The ports in the burner heads must be kept clean at all times for an even, unhampered flame. Clogged or dirty burner ports or electrodes will not allow the burner to operate properly. Replacing Surface Burners Before replacingWKHEXUQHUFDSVKHDGVDQGRYDOKHDG cap assembly, shake out excess water and allow them to dry thoroughly. Replace burner heads in the correct locations according to size. Ensure each cap is properly seated on the burner head, as pictured below. Burner cap is NOT properly seated. Burner cap is NOT properly seated. Burner cap is properly seated. CAUTION Do not operate the cooktop without all burner parts and grates in place. Any spill on or around an electrode must be carefully cleaned. Avoid hitting the electrode with anything hard or it could be damaged. Electrode (on some models) Round hole in burner head must be kept clear The electrode of the spark igniter is exposed when the burner head is removed. When one burner is turned to LITE, all the burners spark. Do not attempt to disassemble or clean around any burner while another burner is on. 49-2000315 Rev. 1