Hunter 21117 Owner's Manual - Page 10
Troubleshooting
View all Hunter 21117 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
7 • Troubleshooting Symptom Possible Causes Solution 1.No functions operate. Main Power not restored. Replace fuse. Turn ON circuit breaker. Turn ON wall switch. Fan pull chain not set to High. Set fan pull chain to High speed. Light pull chain not set to ON. Set light kit to ON. Receiver wiring incorrect. Verify wiring connections. Transmitter and receiver DIP Set transmitter and receiver to same DIP switch setting. switches do not match. Battery too weak. Replace with new, 9 Volt alkaline battery. Refer to "Transmitter Installation", Section 6. 2.Operates only at close range. Signal blocked from reaching Extend antenna into ceiling box, or move it for better receiver. reception. Battery too weak. Replace with new, 9 Volt alkaline battery. Refer to "Transmitter Installation", Section 6. Interference Change the DIP switch settings on the remote receiver and transmitter, 3.Inconsistent operation. Signal partially blocked from Extend antenna into ceiling box, or move it for better reaching receiver. reception. RF interference. Turn OFF wall switch for 5 seconds, then turn back ON. Continuing RF interference. Change DIP switch settings to a different code in both transmitter and receiver. 10 41316-01 • 06/25/10 • Hunter Fan Company