Hunter 21117 Owner's Manual - Page 6
Hunter Fan Company
View all Hunter 21117 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
4 • Receiver Installation NOTE: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire leaving a minimum of 6 inches remaining. Restrip the fan lead wires 1/2 inch. Place remaining excess wire into the ceiling electrical box as needed. Hands Free Figure 7 Hunter Hands-Free™ Canopy: Connect wiring as shown in Figure 7. Place receiver inside mounting bracket. Extend antenna above the ceiling mounting bracket (approximately 3-6˝). Figure 8 Bracket Hanger Bracket Hanger: Starting with the antenna wire, slide receiver inside mounting bracket. If a ground wire mounting screw prevents the receiver from sliding into the bracket, move ground wire and screw to an unused hole at the top of the bracket or secure with a canopy mounting screw. The bracket must remain properly grounded. Connect wiring as shown in Figure 8. Extend antenna above the receiver (approximately 5-8˝). 6 41316-01 • 06/25/10 • Hunter Fan Company