Hunter 24852 Owner's Manual - Page 8
Slide the Canopy/Tail decal under the ceiling
View all Hunter 24852 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3 • Installing the Plane Decal - Cont. 3-6. Loosen the wood screws and remove the decals. 3-7. Use a wood block to drive the metal disk into the ceiling. Note: Metal Disk will leave a permanet marks in ceiling 3-8. Locate one metal disk between the two lines marked for each wheel and center one clip over each line marked where the wings join the Landing gear decal. 3-9. Add the strips of the pressure sensitive rectangle tape to the back side of Canopy/ Tail decal. Locate strips then, peel off one side of the backing and press into place. 3-10. Add a disk of pressure sensitive round tape to each of the 4 metal disk that have been driven into the ceiling. Leave the peel-off backing on the other side of the disks and strips until instructed to remove. 3-11. Peel the backing from the strips on the Canopy/Tail decal and from the disks under the wheels. Do not remove the backing from the disks where the wings attach. 3-12. Slide the Landing Gear decal back under the ceiling plate and align corners with lines marked on tape. Press decal in place at wheels. 3-13. Slide the Canopy/Tail decal under the ceiling plate, align with the landing gear decal and press into place on the ceiling. 3-14. Tighten wood screws securely. Remove the two pieces of tape that mark the corners. Hunter Fan Company Metal Disk Wood Block Hammer Step 3-7 Pressure Sensitive Round Tape Pressure Sensitive Round Tape Step 3-9 Pressure Sensitive Round Tape Pressure Sensitive Round Tape 42813-01 • 09/20/06