Hunter 24852 Owner's Manual - Page 9
See Step 3-15.
View all Hunter 24852 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Canopy/Tail Wing Decal (2) Decal 12" 11" Mark Ceiling in These Locations For Each Wing (Hide Marks Under Wing) Disk Strip Canopy/Tail Decal 191/2" Landing Gear Decal Wing Joint Line Mark Ceiling in These Locations For Each Wing (Hide Marks Under Wing) Wing Decal (2) Wing Joint Line Step 3-15 Landing Gear Decal Mark Ceiling in These Locations For Each Wheel (Hide Marks Under Weel) 3-15. Turn each wing over and mark the approximate dimensions on the back side of the decal. 3-16. Hold each decal in place on the ceiling and mark the ceiling at each location shown in Step 3-15. Use the marks on the back of the decals as a guide. 3-17. Drive 2 metal disk into the ceiling for each wing using the marks just placed in the ceiling as a guide. Peel off one side of the backing on the remaining disks and strips. 3-18. Press the strips onto the decal and the disks onto the clips just driven into the ceiling. See Step 3-15. 3-19. Remove the remaining peel-off backing from all strips and disks. Lift the corner of the Landing Gear decal carefully and remove the backing from the two disks where the wings join. 3-20. Place each wing into position, making sure you are aligned with the metal disk, and press into place. 3-21. After the decal has been installed on ceiling, add two strips of black decal tape over the joint between the wing and body of the plane. 42813-01 • 09/20/06 Hunter Fan Company