Husqvarna AUTOMOWER 430X with installation service Owner Manual - Page 46

WARNING: Only charge the robotic lawnmower using a charging station which is intended for it. Incorrect use may result in electric shock, overheating or leakage of corrosive liquid from the battery. In the event of leakage of electrolyte flush with water and seek medical help if it comes in contact with the eyes etc. 1. Set the main switch to position 1. 2. Place the robotic lawnmower in the charging station. Open the hatch and slide the robotic lawnmower in as far as possible to ensure proper contact between the robotic lawnmower and the charging station. See contact and charging strips in Product overview on page 6 3. The display shows a message that charging is in progress. 4.9 Adjust cutting height The cutting height can be varied from MIN (2 cm) to MAX (6 cm) in nine stages. During the first week after a new installation, the cutting height must be set to MAX to avoid damaging the loop wire. After this, the cutting height can be lowered one step every week until the desired cutting height has been reached. If the grass is long, let the robotic lawnmower to start mowing at the MAX cutting height. Once the grass is shorter, you can gradually lower the cutting height. 4.9.1 To adjust the cutting height CAUTION: During the first week after a new installation, the cutting height must be set to MAX to avoid damaging the loop wire. After this, the cutting height can be lowered one step every week until the desired cutting height has been reached. 1. Press the STOP button to stop the robotic lawnmower and open the hatch. 2. Press the MENU button to access the main menu. 3. Move the cursor using the arrow keys to select Cutting height. a) Press the up arrow key to increase the cutting height. b) Press the down arrow key to lower the cutting height. 4. Press OK. 46 - Operation 236 - 001 - 02.10.2017