Husqvarna AUTOMOWER 430X with installation service Owner Manual - Page 53
Weak GPS signal - automower service
View all Husqvarna AUTOMOWER 430X with installation service manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Message Guide 1 not found Guide 2 not found Guide 3 not found Cause Action The guide wire is not connected to the charg- Check that the guide wire's connector is tight- ing station. ly connected to the charging station. See Lay- ing and connecting the guide wire on page 20. Break in the guide wire. Find out where the break is. Replace the damaged section of the guide wire with a new loop wire and splice using an original coupler. The guide wire is not connected to the boun- Check that the guide wire is connected cor- dary loop. rectly to the boundary loop. See Laying and connecting the guide wire on page 20. Guide calibration failed The robotic lawnmower has failed to calibrate Check that the guide wires are installed ac- the guide wire. cording to the instructions, See Installation of the guide wire on page 19. Guide calibration ac- The robotic lawnmower has succeeded to complished calibrate the guide wire. No action required. GPS navigation prob- Not applicable for Automower 420/440. Prob- Contact your local Husqvarna representative lem lem with the GPS assisted navigation equip- if this message appears often. ment. Weak GPS signal Not applicable for Automower 420/440. The GPS signal is weak for the current working area. GPS assisted navigation cannot be used. If the message appears often, turn off the GPS assisted navigation and instead use the manual settings for Lawn coverage, see Area 1-5 on page 28. Difficult finding home The robotic lawnmower has been following The installation has not been done correctly. the boundary wire several laps without finding See Laying the boundary wire on page 18. the charging station. Wrong corridor width setting on boundary wire. See . The mower was started on a Secondary area with the Main area setting. Temporary problem Please try again. with the server. In case of persisting problems, get in touch with your local Husqvarna representative. Connection problems Problem with the Automower® Connect mod- Restart the mower. If the fault persists, action ule by an authorized service technician will be re- quired. Connection settings Settings for wireless connectivity have been Check and revise settings if necessary. restored restored due to an error. Weak signal Weak GPRS signal for Automower® Connect Make sure the mower is not upside down. If module the problem persists, action by and author- ized service technician will be required. SIM card requires PIN The SIM card must be unlocked. Make sure the correct SIM PIN has been entered into the mower's menu (Network > SIM card). In case of persisting problems, get in touch with your local Husqvarna representative. SIM card locked The SIM card must be replaced. Contact the local Husqvarna representative. SIM card not found Automower® Connect requires a SIM card to Contact your local Husqvarna representative be inserted in the mower. for more information. Geofence problem Your Geofence is not working due to poor (or Contact the local Husqvarna representative. no) communication with GPS system. 236 - 001 - 02.10.2017 Troubleshooting - 53