IBM IC35L040AVVN07-0 Hard Drive Specifications - Page 119
Power-up in Standby Feature Set Device Spin-up
UPC - 683728124212
View all IBM IC35L040AVVN07-0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Command (Subcommand) (S.M.A.R.T Function) SMART Read Attribute Values SMART Read Attribute Thresholds SMART Enable/Disable Attribute Autosave SMART Save Attribute Values SMART Execute Off-line Data Collection SMART Read Log SMART Write Log SMART Enable Operations SMART Disable Operations SMART Return Status SMART Enable/Disable Automatic Off-line (Set Features) Enable Write Cache Set Transfer Mode Enable Advanced Power Management Enable Power-up in Standby Feature Set Power-up in Standby Feature Set Device Spin-up Enable Address Offset Mode Enable Automatic Acoustic Management 52 bytes of ECC apply on Read/Write Long Disable read look-ahead feature Enable release interrupt Disable reverting to power on defaults Disable write cache Disable Advanced Power Management Disable Power-up in Standby Feature Set Disable Address Offset Mode Enable read look-ahead feature 4 bytes of ECC apply on Read/Write Long Disable Automatic Acoustic Management Enable reverting to power on defaults Disable release interrupt Command code Feature (Hex) Register (Hex) B0 D0 B0 D1 B0 D2 B0 D3 B0 D4 B0 D5 B0 D6 B0 D8 B0 D9 B0 DA B0 DB EF 02 EF 03 EF 05 EF 06 EF 07 EF 09 EF 42 EF 44 EF 55 EF 5D EF 66 EF 82 EF 85 EF 86 EF 89 EF AA EF BB EF C2 EF CC EF DD Figure 89. Command set (Subcommands) Figure 87 beginning on page 103 shows the commands that are supported by the device. Figure 89 shows the subcommands that are supported by each command or feature. The following symbols are used in the command descriptions: Output Registers 0 Indicates that the bit must be set to zero. 1 Indicates that the bit must be set to one. D The device number bit. Indicates that the device number bit of the Device/Head Register should be specified. Zero selects the master device and one selects the slave device. H Head number. Indicates that the head number part of the Device/Head Register is an output parameter and should be specified. Deskstar 120GXP hard disk drive specifications 105