Icom IC-9100 Instruction Manual - Page 49
About the 5 MHz frequency band operation only USA version
View all Icom IC-9100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
3 BASIC OPERATION D About the 5 MHz frequency band operation (only USA version) Operation on the 5 MHz band is allowed on 5 discrete frequencies and must adhere to the following: • The USB mode • Maximum of 50 watts ERP (Effective Radiated Power) • 2.8 kHz bandwidth IC-9100 Displayed Frequency* 5.33050 MHz 5.34650 MHz FCC Channel Center Frequency* 5.33200 MHz 5.34800 MHz It's your responsibility to set all controls so that trans- 5.36650 MHz 5.36800 MHz mission in this band meets the stringent conditions 5.37150 MHz 5.37300 MHz under which amateur operations may use these frequencies. 5.40350 MHz 5.40500 MHz 1 NOTE: We recommend that you store these frequencies, mode and filter settings into memory To assist you in operating the 5 MHz band within the rules specified by the FCC, transmission is illegal on 2 channels for easy recall. any 5 MHz band frequency other than the five fre- quencies shown in the table above. 3 *The FCC specifies center frequencies on the 5 MHz band. However, the IC-9100 displays carrier 4 frequency. Therefore, tune the transceiver to 1.5 kHz below the specified FCC channel center 5 frequency. 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 40