Icom ID-52A Instructions - Page 4

Setting up from a PC using a USB cable Step 4 Reading the settings from the transceiver Follow the steps below to write the setting data that is edited with the CS-52 to the transceiver using a USB cable. zz Click , or select "Read ← TR" in the menu to read the data from the transceiver. NOTE: Make a backup copy of the original setting data on the PC before editing. Step 5 Editing the parameters zz Enter Memory channels, call signs, repeater lists, set scan and other settings using the CS-52. LLSee the CS-52 Help file for assistance. LLSave the setting data in the Icom Cloning Format (ICF) file format in a folder on your PC. While reading from the transceiver TIP: If you have an ICF file to write to the transceiver, click or select "Open... Ctrl+O" in the menu, and then select the file. Step 6 Setting the transceiver to the Clone mode zz Set the transceiver to the Clone mode. (MENU > SET > Others > Clone > Clone Mode) •• "Ready..." is displayed. Step 7 Writing the setting data to the transceiver You can write the edited Memory channels, call signs, repeater list, scan and other settings to the transceiver. NOTE: Writing the setting will overwrite the current setting data on the transceiver. 1. Click , or select "Write → TR" in the menu. 2. Select the items you want to write to your transceiver, and then click . 3. Click on the confirmation dialog. •• Starts writing to the transceiver. 4. After the writing is completed, turn OFF the transceiver, then turn it ON again to operate it with the edited setting data. While writing to the transceiver Writing completed 4