Image Fitness 5.0 Bench User Manual - Page 12

22. Route the Bench Cable (58) under a 4 1/2" Pulley 22 (35). Attach the Pulley to the Front Leg (18) with an M10 x 75mm Bolt (73), two 17mm Spacers (96), two M10 Washers (79), and an M10 Nylon Locknut (77). 77 79 18 23. Attach the Bench Cable (58) to the Back Leg (39) 23 with a Cable Clip (28). 96 35 58 96 79 73 24. Press a 19mm Round Inner Cap (48) into each end of the three Pad Tubes (41). Slide two Pad Tubes (41) through the holes in the Leg Lever (19). Slide the third Pad Tube through the holes in the Front Leg (18). Slide two Foam Pads (42) onto each Pad Tube. 24 42 48 41 25. Locate the High Cable (61). See the inset drawing. Slide a Cable Ball (56) onto the end of the High Cable (61). Thread an M6 Locknut (80) onto the Cable as far as it will go. Tighten a Cable Eye (57) onto the Cable. Hold the Cable Eye and fully tighten the Locknut against the Cable Eye. Slide the Cable Ball over the Locknut and the Cable Eye. Route the end of the High Cable (61) without a Cable Ball (56) through the tube on the left Pulley Arm (7). Wrap the Cable around a 4 1/2" Pulley (35) and attach the Pulley to the Pulley Arm with an M10 x 45mm Bolt (76) and an M10 Nylon Locknut (77). Note: Be sure the Cable is under the indicated pin on the Pulley Arm. 25 61 56 80 57 12 39 28 58 42 42 48 19 18 7 77 Pin 61 56 Tube 76 35