Image Fitness 910 Treadmill Owners Manual - Page 10
Maintenance, Trouble, Shooting
View all Image Fitness 910 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
MAINTENANCE AND TROUBLE-SHOOTING Check all parts periodically to ensure that they are tightened securely. Outside surfaces of the treadmill can be cleaned using a damp cloth and mild, non-abrasive detergent. Do not allow liquids to come in contact with the console. WALKING BELT ADJUSTMENT The walking belt should always be kept centered on the walking platform. If the belt shifts to the right or left sides of the platform, the belt may be damaged by the roller guard screws. The belt can be adjusted using the rear roller adjustment bolts and the alien wrench included. CAUTION: ALWAYS TURN THE POWER OFF BEFORE ADJUSTING THE WALKING BELT. IF THE WALKING BELT HAS SHIFTED TO THE LEFT: TURN THE POWER OFF. Turn the left adjustment bolt clockwise, and the right adjustment bolt counterclockwise, 1/4 of a turn each. Turn the power on. Repeat as necessary until the belt is centered. . 0 IF THE WALKING BELT HAS SHIFTED TO THE RIGHT: TURN THE POWER OFF. Turn the left adjustment bolt counterclockwise, and the right adjustment bolt clockwise, 1/4 of a turn each. Turn the power on. Repeat as necessary until the belt is centered. IF THE WALKING BELT SLIPS DURING USE: TURN THE POWER OFF. Turn both adjustment bolts clockwise 1/4 of a turn. Turn the power on. Repeat as necessary until the belt does not slip. Be careful not to overtighten the bolts. Overtightening can stretch the belt, cause excessive roller noise, and reduce motor performance. To check the walking belt for proper tension, TURN THE POWER OFF, and lift the edges of the walking belt. You should be able to lift each edge 3-4 inches off the walking platform. The center of the belt should remain just at the surface of the platform. . e e e...z,.. 3N-4" The alien wrench can be stored conveniently on the selfadhesive wrench clip. ROLLER GUARD ADJUSTMENT The rear edge of the roller guards should be 1/8 inch from touching the rear roller. To adjust the roller guards, loosen the screws in the roller guards, slide the roller guards forward or backward, and retighten the screws. 10 I . Roller Bracket Wrench Clip-- 914 Roller Guard . ..._...- Rear Roller