Intermec CV61 CV61 Direct Wiring Kit Installation Instructions - Page 10

Connect to the Top Battery Terminal 1 Remove positive battery terminal side post bolt from the vehicle battery. Negative wire (green) Ground wire (black) Positive wire (red) Nut Washers 2 Fasten a 3/8-inch nut to one of the 3/8 x 1-1/2-inch battery terminal posts. 3 Place a 3/8-inch washer on the battery terminal post. 4 Slide the positive wire (red) fuse link terminal ring from the power input cable onto the the positive battery post. 5 Place another 3/8-inch washer on the battery terminal post. 6 Slide the vehicle positive wire onto the battery terminal post. 7 Thread the post assembly (Steps 2 through 6) into the positive battery terminal. 8 Tighten the battery terminal post securely. 9 Tigthen the nut installed in Step 2 to secure the washers and cables firmly in place. 10 Repeat Steps 1 through 9 for the negative wire. 11 Connect the 6-pin connector the the CV61. 12 Connect the ground strap. For help, see the next section. 10 CV61 Direct Wiring Kit Installation Instructions