Intermec CV61 CV61 Direct Wiring Kit Installation Instructions - Page 7

To assemble the power cable 1 Route the power cable from the CV61 to the vehicle battery. 2 Cut the power cable near the battery leaving enough of the cable to reach the battery terminals. Ground wire (black) Battery cable jacket Positive wire (red) Heat shrink tubing Fuse Negative wire (green) Terminal ring 3 Strip the power cable jacket back 31 to 36 cm (12 to 14 in). 4 Cut a piece of heat shrink tubing and place it over the power cable jacket. 5 Insert and secure the fuse into the fuse block assembly. 6 Assemble the red wire: a Cut a strip of red wire that is 5.08 cm (2 in) long. b Strip 0.60 cm (0.25 in) of insulation from the red wire attached to the battery cable and on both ends of the wire that you just cut. c Crimp the red wire you cut to the other end of the fuse block. d Crimp a 3/8-inch terminal ring onto the red wire. CV61 Direct Wiring Kit Installation Instructions 7