Intermec CV61 CV61 Direct Wiring Kit Installation Instructions - Page 9
Connect to the Side Battery Terminal
View all Intermec CV61 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Connect to the Side Battery Terminal 1 Remove both battery terminal side post bolts from the vehicle battery. Negative wire (green) Ground wire (black) Positive wire (red) Nut Washers Positive battery terminal post 2 Place a 3/8-inch washer onto each end of the battery clamp bolt. 3 Slide the positive fuse link terminal ring from the power cable onto positive battery clamp bolt. 4 Place another 3/8-inch washer onto the battery clamp. 5 Thread another 3/8-inch nut onto the battery clamp bolt, and tighten the nut securely. 6 Repeat Steps 1 through 5 for the negative wire. 7 Connect the ground wire. For help, see "Fasten the Ground Wire" on page 11. CV61 Direct Wiring Kit Installation Instructions 9
CV61 Direct Wiring Kit Installation Instructions
9
Connect to the Side Battery Terminal
1
Remove both battery terminal side post bolts from the
vehicle battery.
2
Place a 3/8-inch washer onto each end of the battery clamp
bolt.
3
Slide the positive fuse link terminal ring from the power
cable onto positive battery clamp bolt.
4
Place another 3/8-inch washer onto the battery clamp.
5
Thread another 3/8-inch nut onto the battery clamp bolt,
and tighten the nut securely.
6
Repeat Steps 1 through 5 for the negative wire.
7
Connect the ground wire. For help, see
“Fasten the Ground
Wire” on page 11
.
Nut
Washers
Positive battery
terminal post
Positive
wire (red)
Negative
wire (green)
Ground
wire (black)