Invacare L-4R Owners Manual - Page 49

12.4 Installing/Removing/Using the Walker Holder 12 ACCESSORIES ƽ WARNING After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely. The installation of the walker holder onto the back of the scooter seat significantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.  For this procedure, refer to FIGURE 12.4. Installing/Removing the Walker Holder  Reverse this procedure to remove the walker holder. 1. If necessary, loosen but DO NOT remove the mounting knob. 2. Install the walker holder into the accessory tube. 3. Thread the mounting knob into the welded nut on the accessory tube. Securely tighten. Using the Walker Holder 1. Fold walker. Refer to walker instructions.  Walker MUST be folded before using walker holder. 2. Hang folded walker on walker holder hooks. 3. Secure walker with hook and loop straps. Walker Holder Hook Accessory Tube Hook and Loop Strap Mounting Knob Insert Into Accessory Tube Part No. 1143205 FIGURE 12.4 Installing/Removing the Walker Holder 49 Lynx™L-3 & Lynx L-4 Scooters