Invacare L-4R Owners Manual - Page 54

14 TROUBLESHOOTING 14.2 Service Indicator Error Codes  For the following table, refer to FIGURE 6.1 on page 25. FLASH DESCRIPTION 1 Battery Low 2 Low Battery Fault 3 High Battery Fault 4 Current Limit Time-out 5 Park Brake Fault 6 Throttle OONAPU 7 Speed Pot Fault 8 Motor Voltage Fault 9 Other error 10 Push/Rollaway Fault MEANING The batteries are running low. • Recharge the batteries. The batteries have run out of charge. • Recharge the batteries. Battery voltage is too high. This may occur if overcharged &/or traveling down a long slope. • If traveling down a slope, reduce your speed to minimize the amount of regenerative charging. • Check the battery and associated connections and wiring. The motor has been exceeding its maximum current rating for too long. This may be due to a faulty motor. • Check the motor and associated connections and wiring. • Turn the controller off, leave for a few minutes and turn back on again. Either a park brake release switch is active or the park brake is faulty. • Check the park brake and associated connections and wiring. • Ensure any associated switches are in their correct positions. The Throttle is out of neutral when turning the controller on. • Ensure the throttle is in neutral when turning the controller on. • The Throttle may require re-calibration. The throttle, speed limit pot, SRW or their associated wiring may be faulty. • Check the throttle and speed pot and associated connections and wiring. The motor or its associated wiring is faulty. • Check the motor and associated connections and wiring. The controller may have an internal fault. • Check all connections & wiring. The scooter has exceeded the Push or Rollaway speed limits. • Turn the controller off and then on again. Lynx™L-3 & Lynx L-4 Scooters 54 Part No. 1143205