JVC JY-VS200U JY-VS200U User Manual -- Pages 2-35 (1231KB) - Page 22
NOTE: Recording From The Middle Of A Tape
View all JVC JY-VS200U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
EN23 NOTE: Recording From The Middle Of A Tape Time Code During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback. If recording starts from a blank portion, the time code begins counting from "00:00:00" (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number. To perform Random Assemble Editing (੬ pg. 65 - 70), time code is necessary. If during recording a blank portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from "00:00:00". This means the camcorder may record the same time codes as those existing in a previously recorded scene. T o prevent this, perform "Recording From The Middle of A Tape" below in the following cases; • When shooting again after playing back a recorded tape. • When power shuts off during shooting. • When a tape is removed and re-inserted during shooting. • When shooting using a partially recorded tape. • When shooting on a blank portion located partway through the tape. • When shooting again after shooting a scene then opening/closing the cassette holder cover . Display 12 : 34 : 24 Frames are not displayed during recording. Minutes Seconds Frames (30 frames = 1 second) Recording From The Middle Of A Tape 1. Play back a tape or use Blank Sear ch (੬ pg. 43) to find the spot at which you want to start recording, then engage the Still Playback mode ( ੬ pg. 40). 2. Set the Power Switch to " " or " " while pressing down the Lock Button located on the switch, then start recording. NOTES: ● The time code cannot be reset. ● During fast-forwarding and rewinding, the time code indication does not move smoothly . ● The time code is displayed only when "TIME CODE" is set to "ON" (੬ pg. 31, 41). When a blank portion is recorded on a tape Time code 00:00:00 Time code 05:43:21 Time code 00:00:00 Tape Already recorded scene Blank Newly recorded scene Shooting start point Proper recording Time code 00:00:00 Shooting stop point Shooting start point Time code 05:43:21 Time code 05:44:00 Tape Already recorded scene New scene Latest scene Shooting start point Shooting start point Shooting start point JY-VS200U EN 02-35 23 01.3.12, 6:55 PM