JVC JY-VS200U JY-VS200U User Manual -- Pages 2-35 (1231KB) - Page 33
Fade/Wipe Effects
View all JVC JY-VS200U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
34 EN RECORDING Advanced Features For Video And D.S.C. (cont.) Fade/Wipe Effects These effects let you make pro-style scene transitions. Use them to spice up the transition from one scene to the next. You can also vary transitions from scene to scene. IMPORTANT: Some Fade/Wipe Effects cannot be used with certain modes of Program AE with special effects ( ੬ pg. 36, 37). If an unusable Fade/ Wipe Effect is selected, its indicator blinks or goes out. FADE/WIPE SELECTION and ) Fade or Wipe works when video recording is started or when you stop recording. 1 Set the Shooting Mode Switch to "VIDEO" and set the Power Switch to " " while pressing down the Lock Button located on the switch. Pull out the viewfinder fully or open the LCD monitor fully. 2 Press the MENU wheel. The Menu Screen appears. Shooting Mode Switch 3 Set "CAMERA MODE" to "VIDEO" or "PS-VIDEO" in the Menu Screen (੬ pg. 28, 29). Power Switch 4 Rotate the MENU wheel to select " FADER/WIPE", then press it. Rotate the MENU wheel to select the desired function, then press it. Selection is complete. Recording Start/ Stop Button FADE/WIPE Button 5 Press the MENU wheel again. The Menu Screen closes. 6 To activate the Fade-in or Wipe-in . . . .... Press FADE/WIPE during Record-Standby mode so that the selected effect indicator appears. To activate the Fade-out or Wipe-out . . . .... Press FADE/WIPE during recording so that the selected effect indicator appears. 7 Press the Recording Start/Stop Button to activate the Fade-in/out or Wipe-in/out. MENU Wheel To Deactivate The Selected Effect . . . .... press FADE/WIPE again in step 6 so that the effect indicator disappears. NOTES: ● You can extend the length of a Fade or W ipe by pressing and holding the Recording Start/ Stop Button. ● If the power is turned off after a scene is finished recording, the stored point is erased, disabling the Picture Wipe/Dissolve combination. When this happens, the Picture W ipe/ Dissolve indicator blinks. Also note that power shuts off automatically if 5 minutes elapse in the Record-Standby mode. ● Picture Wipe/Dissolve cannot be used when "CAMERA MODE" is set to "PS-VIDEO". ● All Fade/Wipe Effects cannot be used when "CAMERA MODE" is set to "DUAL". ● The sound at the end of the last recorded scene is not stored. PICTURE WIPE OR DISSOLVE SELECTION and ) The Picture Wipe or Dissolve works when video recording is started. 1 Follow steps 1 through 5 above. 2 Engage the Record-Standby mode. If you press FADE/WIPE during recording . . . .... press the Recording Start/Stop Button when one scene is finished. The point at which the scene ended is stored in memory. If you press FADE/WIPE during Record-Standby mode . . . .... press the Recording Start/Stop Button to start recording and press it again when one scene is finished. The point at which the scene ended is stored in memory. 3 If you start recording a new scene within 5 minutes of the end of the previous recording (without having turned the camcorder 's power off), the previous scene wipes out, revealing the new scene. JY-VS200U EN 02-35 34 01.3.12, 6:55 PM