JVC KY-F560U KA-F5602U, KA-F5603U Studio kit for KY-F560U camera (47 page inst - Page 18

Connecting RM-P210 Connecting to Remote Control Unit RM-P210 Headset KA-310U 26 Pin camera cable TALLY CALL FULL AUTO F1 BARS F2 INTERCOM LEVEL SHUTTER GAIN REMOTE CONTROL UNIT RM-P210 F3 MENU/SHUTTER GAIN STEP HIGH PAINT WHITE AUTO W.BAL B MASTER BLACK IRIS SHUTTER VARIABLE MID F4 MENU PUSH-ON PUSH-ON LOW R A B PRESET AUTO MANU POWER I DOWN UP DOWN UP O CLOSE OPEN Remote control unit RM-P210 RM Multi-pin connector PUSH AW BARS MENU SET REMOTE LENS GENLOCK IN VIDEO OUT DC IN SEE INST POWER INTERCOM INCOM MIC VF ON CARBON OFF DYNAMIC INCOM LEVEL CALL MIN MAX Headset KA-310U [INTERCOM] terminal Monitor 4 5 7 10 15 30 ft 1.2 1.5 2 3 5 10 m 5.5 10 C 16 11 8 F.f MACRO PROMPTER OUTPUT RM BREAKER 26 Pin camera cable VC-P110 (5 m) VC-P112 (20 m) VC-P113 (50 m) VC-P114 (100 m) [PROMPTER OUTPUT] terminal Connection Switch off RM-P210 power supply before attempting the connection. ● Connect this unit's RM multi-pin connector and RM-P210 using the 26 Pin camera cable. Length of the camera cable should not be longer than 100 m. ● If intercom headset is to be used, plug the Headset KA-310U into the [INTERCOM] termi- nal. ● Prompter video (RM-P210 [AUX VIDEO INPUT] terminal's input signal) from RM-P210 could be verified by connecting this unit's [PROMPTER OUTPUT] terminal located in front of it to a monitor using BNC cable. Note Power for this unit and the camera is supplied by RM-P210 via the 26 Pin camera cable. Setting Ⅵ Menu screen setting ● Composite video signal is always output at the RM multi-pin connector.In addition, another type of video signal which could be either RGB component, Y/Cb/Cr component or YC separate signal could be outputted. The output signal could be selected using the "OUTPUT" item under the "SYSTEM" menu screen. ● If the output signal is RGB component, option to superimpose SYNC signal onto the G signal could be selected through the "SYNC ON G" item under the "SYSTEM" menu screen. 18