Kenwood DNX573S Instruction manual - Page 93
Crossover network setup, Middle, Large in <Speaker Setup>.
View all Kenwood DNX573S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Controlling Audio Crossover network setup You can set a crossover frequency of speakers. 1 Touch [X'over]. X'over screen appears. 2 Touch the speaker to set. 3 Set each item as follows. Phase Inversion*2 Sets the phase of subwoofer output. Check [Phase Inversion] to shift the phase 180 degrees. (When subwoofer is selected on Speaker Select screen) *1 Only when "Tweeter" is set to "Small", "Middle", "Large" in . *2 Only when "Subwoofer" is set to a mode other than "None" in . *3 Only when "LPF FREQ"/"HPF FREQ" is set to a mode other than "Through" in
Controlling Audio
92
92
Crossover network setup
You can set a crossover frequency of
speakers.
1
Touch [X’over].
X’over screen appears.
2
Touch the speaker to set.
3
Set each item as follows.
HPF FREQ
High Pass Filter adjustment. (When front or rear
speaker is selected on Speaker Select screen)
LPF FREQ
Low Pass Filter adjustment. (When subwoofer
is selected on Speaker Select screen)
Slope*
3
Sets a crossover slope.
Gain
Adjusts the front speaker, rear speaker, or
subwoofer level.
TW (Tweeter) Gain *
1
Adjusts the tweeter level. (When front is
selected on Speaker Select screen)
Phase Inversion*
2
Sets the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees. (When subwoofer is selected on
Speaker Select screen)
*
1
Only when “Tweeter” is set to “Small”,
“Middle”, “Large” in <Speaker Setup>.
*
2
Only when “Subwoofer” is set to a mode
other than “None” in <Speaker Setup>.
*
3
Only when “LPF FREQ”/“HPF FREQ” is set to
a mode other than “Through” in <X’over>.