Kenwood DNX6180 Quick Start Guide - Page 18

Basic Operations of Remote Control Battery installation 1 Use two "AAA"/"R03"-size batteries. 2 Insert the batteries with the + and - poles 3 aligned properly, following the illustration inside the case. 4 5 6 7 8 9 Notes 0 If the Remote Controller operates only over shorter distances or does not operate at all, it is possible that the batteries are depleted. In such instances, replace the both batteries with new ones. AUD U DVD U TVU U = NAV ~ ! @ ¤ CAUTION • Put the Remote Controller in a place where it will not move during braking or other operations. A dangerous situation could result, if the Remote Controller falls down and gets wedged under the pedals while driving. • Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat generation may result. • Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause the battery to leak fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse with water and consult a physician. • Place the battery out of reach of children. In the unlikely event that a child swallows the battery, immediately consult a physician. 18 | Quick Start Guide Remote Controller mode switch • AUD mode: Switch to this mode when controlling a selected source or tuner source, etc. • DVD mode: Switch to this mode when playing DVDs or CDs etc. with the player integrated in this unit. • TV mode: Switch to this mode when controlling TV. • NAV mode: Switch to this mode when controlling Navigation unit. Notes When controlling a player that is not integrated in the unit, select "AUD" mode.