Kenwood DNX6180 Quick Start Guide - Page 22
Connection - red light cameras
UPC - 019048192714
View all Kenwood DNX6180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Connection Ignition key switch ¤ Installation of this unit requires skills and experience so leave the mounting and wiring to professionals. When the unit is being installed the wiring should be connected via the vehicles' fuse box ensuring the correct amperage is used. Failure to do so may result in damage to the unit and/or the vehicle or may result in fire, etc. ACC Red (Ignition wire) Car fuse box Car fuse box (Main fuse) A Yellow (Battery wire) Black (Ground wire) - (To car chassis) Antenna Cord FM/AM antenna input A Battery ⁄ Connect to the vehicle's parking brake detection switch harness. Light Green (Parking sensor wire) PRK SW For safety reasons, be sure to connect the parking sensor. Connect to vehicle's reverse lamp harness when using the optional rear view camera. To steering remote ⁄ To use the steering wheel remote control feature, you need an exclusive remote adapter (not supplied) matched to your car. To car light control switch Connect to the terminal that is grounded when either the telephone rings or during conversation. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. When using the optional power amplifier, connect to its power control terminal. ⁄ If no connections are made, do not let the cable come out from the tab. 22 | Quick Start Guide