Kenwood KDC-MP208 Instruction Manual - Page 18

Troubleshooting Guide - protect

Get Kenwood KDC-MP208 - Radio / CD PDF manuals and user guides
UPC - 019048174413
View all Kenwood KDC-MP208 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Troubleshooting Guide Some functions of this unit may be disabled by some settings made on this unit. D Cannot display the user of System Q. ~ (page 6) is not set. D .Cannot set up the subwoofer. • No output from the subwoofer. • Cannot set up the low pass filter. ~ • Preout is not set to subwoofer. 1& (page 10) • (page 4) is not set to On. D . Cannot register a security code. • Cannot set up Display. ~ (page 12) is not turned off. D Cannot play audio files. ~ "CD READ" is set to "2". 1& (page 10) What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. Tuner source DRadio reception is poor. V' The car antenna is not extended. .,.. Pull the antenna out all the way. Disc source D The specified disc does not play, but another one plays instead. V' The specified CD is quite dirty. I@' Clean the CD. 'j;"Th'e'Ciisc'(s'fo' Press the reset button on the unit. If the "Ell" code does not disappear, consult your nearest service center. E-99: Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason. 0:.'> Check the disc magazine. And then press the reset button on the unit. If the "E-99" code does not disappear, consult your nearest service center. IN (Blink): The CD player section is not operating properly. r:> Reinsert the CD. If the CD cannot be ejected or the display continues to flash even when the CD has been properly reinserted, please switch off the power and consult your nearest service center PROTECT/DCER:The speaker wire has a short-circuit or touches the chassis of the vehicle, and then the protection function is activated. -=:> Wire or insulate the speaker cable properly and press the reset button. If the "PROTECT"I"DCER" code does not disappear, consult your nearest service center. NA FILE: An Audio file is played with a format that this unit can't support. -=:> ---- COPY PRO A copy-protected file is played. -=:> ---- 18 I KDC-MP238/CR/KDC-MP208/KDC-138/CR

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
Troubleshooting Guide
Some functions
of
this unit may be disabled by
some settings made on this unit.
D
Cannot display the user
of
System
Q.
~
<Audio Control> (page
6)
is
not
set.
D
.
Cannot set up the subwoofer.
• No
output
from the subwoofer.
• Cannot set up the low
pass
filter.
~
• Preout
is
not
set
to
subwoofer.
1&
<Menu
System>
(page
10)
• <Subwoofer
Output>
(page
4)
is
not
set
to
On.
D
.
Cannot register a security code.
• Cannot set up Display.
~
<Demonstration
mode
Setting> (page
12)
is
not
turned off.
D
Cannot play audio files.
~
"CD
READ"
is
set
to
"2".
1&
<Menu
System> (page
10)
The messages shown below display your
systems condition.
TOC
ERRlE-04:
• No disc
has
been loaded in the disc
magazine.
• The
CD
is
quite dirty. The
CD
is
upside-
down. The
CD
is
scratched a lot.
E-OS:
The disc
is
unreadable.
E-15:
Media
was
played that doesn't have data
recorded that the unit can
play.
E'll:
The unit
is
malfunctioning for some reason.
c:>
Press
the reset button on the unit. Ifthe
"E-
ll"
code does
not
disappear, consult your
nearest service center.
E-99:
Something
is
wrong with the disc magazine.
Or the unit
is
malfunctioning for some
reason.
0:.'>
Check the disc magazine. And then
press
the reset
button
on the unit. If the
"E-99"
code does not disappear, consult your
nearest service center.
IN
(Blink):
The
CD
player section
is
not operating
properly.
r:>
Reinsert the
CD.
If the
CD
cannot be
ejected or the display continues to
flash
even when the
CD
has
been properly
reinserted, please switch
off
the power
and consult your nearest service center
PROTECT/DCER:The
speaker wire
has
a short-circuit or
touches the
chassis
of
the vehicle, and then
the protection function
is
activated.
-=:>
Wire or insulate the speaker cable
properly and
press
the reset button. If
the
"PROTECT"I"DCER"
code does not
disappear, consult your nearest service
center.
What
might
seem
to
be a malfunction
in
your unit
may just
be
the result
of
slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
Tuner source
D
Radio reception
is
poor.
V'
The
car
antenna
is
not
extended.
.,..
Pull the antenna
out
all the way.
Disc source
D
The specified disc does not play, but another one
plays instead.
V'
The specified
CD
is
quite dirty.
I@'
Clean the
CD.
'j;"Th'e'Ciisc'(s'fo'<ideci'i'ri'ij'diHerent'siot from that
specified.
\@'
Eject the disc magazine and check the
number
,,,,,,
,~<?!,
~,~,~,
s
J?e
fi.fj
~~,
d,
i
sc,
__
"""",
V'
The disc
is
severely scratched.
...-
Try
another disc instead.
Audio file source
D
The sound skips when an Audio file
is
being
played.
V'
The media
is
scratched
or
dirty.
1&
Clean the media, referring
to
the
CD
cleaning
of
the section
on
<Handling CDs> (page
3).
'j;"Th'e'rec'o'rding'co'ri'diiion'is'ba'd'.""
.,..
Record the media again or
use
another media.
18
I
KDC
-MP238/CR/KDC-MP208/KDC-138/CR
NA
FILE:
COPY
PRO
An
Audio file
is
played with a format that this
unit can't support.
-=:>
----
A copy-protected file
is
played.
-=:>
----