Kenwood VR-5700 User Manual 1 - Page 41
Basic Operation of Remote Control Unit, Remote Setup
View all Kenwood VR-5700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Chapter Two : Setting Up the Remote Control Unit Basic Operation of Remote Control Unit Remote Setup Remote Control unit is a new type of Remote Control unit which receives information from the receiver and display it on the LCD screen. This section describes the basic operations of Remote Control unit. Turning power on: To turn the receiver on: Press the SYS.POWER button. To turn the connected device on: Press the AV POWER button. (It is necessary to perform the procedure in "Identifying Components for Remote Control Unit" on page 39 to enable remote control of AV devices.) Selecting the input: Audio device: Press the MUSIC button repeatedly. The input names where audio devices are identified by Remote Control unit will be shown on the LCD screen. 1CD1 : 2MD/Tape1 : 3Tuner : 4CD-R : 5Phono : If an audio device which is connected to an input is not identified by Remote Control unit, the device name is skipped and not displayed. Video device: Press the MOVIE button repeatedly. The input names where video devices are identified by Remote Control unit will be shown on the LCD screen. 1Video1 : 2Video2 : 3Video3 : 4Video4 : 5DVD/6ch : 6AV AUX : If a video device which is connected to an input is not identified by Remote Control unit, the device name is skipped and not displayed. (VR-5080 only) Although Video4 is displayed in the initial status, the receiver cannot be switched to select Video4. The Video4 display will not appear after the Remote Control unit has been set up. TV: Press the TV button. The LCD screen shows TV if this is registered in and identified by Remote Control unit. Adjusting the receiver's volume: Press the VOL. (+/-) button until the desired volume is obtained. + VOL. - VOL. Muting audio temporarily: Press the MUTE button. To resume the original volume, press the MUTE button again or press one of the VOL. (+/-) buttons. Using the numeric buttons: When entering a figure directly for selecting a CD track number, etc., press the numeric buttons as shown below. To enter 5 : To enter 25 : or : 2 The button to be pressed varies depending on the function. Screen menu control operation 2WAY LCD REMOTE CONTROL UNIT REC 01.IR 02.Surround 03.Contrast Home Enter LCD LCD Function Function button 1 button 2 35 The contents of the function buttons vary according to current situations, and the function names (Next, Back, Enter, etc.) are shown on the screen. For details, see the description of each control operation. Press to select an item by scrolling the screen menu up or down. The selected item is displayed in an inverted color.