Kenwood VR-5700 User Manual 1 - Page 45
Identifying Components for Remote Control Unit, Surround, Contrast, Enter, Tuner, FMF01ch, F87.50MHz
View all Kenwood VR-5700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Chapter Two : Setting Up the Remote Control Unit Identifying Components for Remote Control Unit Remote Setup After the speaker setup, it is required to make Remote Control unit capable of identifying the devices it controls. Remote Control unit provided with the receiver can be used in setup of any device. Even when a device is not listed in the device codes in the Remote Control unit memory, the remote control function of the device can be programmed using the Learn function. The Learn function can also be used to extend the remote controllable functions. For details, see "If a device cannot be remote controlled with any code in the list, or to add remote control target functions..." on page 40. Registering a device 1. Ensure that the batteries are loaded. Press the MUSIC button or MRECOVIE button to display "Menu". Tuner FMF01ch F87.50MHz FFFFFFMenu 2. Press the Menu button (LCD function button 2). HomeFFFSetup 3. Press the Setup buttoRnEC(LCD function button 2). 01.IR 02.Surround 03.Contrast Home Enter 4. Select "01. IR" using the or button, then press the Enter button (LCD function button 2). 01.CD1 02.MD/Tape1 03.CD-R BackFFEnter 5. See "Noting Your Devices" on page 3 to check the devices and the jacks to which they are connected. 6. Select a device connection jack name (CD1, MD/Tape1, etc.) using the or button, then press the Enter button (LCD function button 2). 01.CD 02.Tape 03.MD BackFFEnter 7. Select the device name connected to the jack (CD, Tape, etc.) using the or button, then press the Enter button. Kenwood Adcom Aiwa BackFFEnter 8. Select the manufacturer name of the device using the or button, then press the Enter button. If the manufacturer name of the device is not listed, se- 39 lect "Nothing" and press the Enter button. In this case, the code can be programmed using the Learn function (see page 40). 01.0505 02.Nothing BackFFEnter 9. Select the setup code of the device (each device has a remote control identification number matching it) us- ing the or button. • When the device is connected through a Kenwood system control cord, select System. In this case, the remote control signal is sent to the receiver then to the device connected to it.