Kenwood VR-5700 User Manual 1 - Page 46
If a device cannot be remote controlled with any code in the list
View all Kenwood VR-5700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Chapter Two : Setting Up the Remote Control Unit Remote Setup 10. Press the AV POWER button. MUSIC AV POWER MOVIE TV SYS.POWER Pressing the AV POWER button causes Remote Control unit to transmit the signal turning on/off the device being set. The device is turned on if the selected setup code is correct. If it is not turned on, select another code and press the AV POWER button again. In case it cannot be turned on by any code, see "If a device cannot be remote controlled with any code in the list, or to add remote control target functions..." on this page. Skip this step if System is selected in the setup code selection. 40 11. After ensuring that the setup code is correct, press the Enter button. 12. The display in step 4 re-appears. Set other devices by repeating steps 5 to 12 for each of them. To change a setup code: When a new device is purchased to replace the previously connected device, it is required to let Remote Control unit identify the new device as described below. 1. Connect the new device (see pages 3 to 32). 2. Perform the procedure in "Identifying Components for Remote Control Unit" on page 39 to select the jacks of the new device and enter a new setup code. The newly selected code replaced the previous code at the moment the Enter button is pressed to save the new code. To delete a setup code: When a device is disconnected and no replacing device is connected, it is required to remove the setup code from this Remote Control unit memory as described below. 1. Perform the procedure in "Identifying Components for Remote Control Unit" on page 39 to select the jacks where the disconnected device was connected. 2WAY LCD REMOTE CONTROL UNIT 2. In step 6, select "Delete", "No Type" or by scrolling the device names. This makes Remote Control unit no longer identify the device. • If you select Delete, the setup is deleted together with the input name. For example, once you delete VIDEO1 to VIDEO3, the VIDEO1 to VIDEO3 inputs are skipped even when they are selected. • If you select No Type, the input name is displayed but only the registered device name is deleted. If a device cannot be remote controlled with any code in the list, or to add remote control target functions... This Remote Control unit incorporates an advanced Learn function which makes it possible to program remote control signals used by another Remote Control unit in itself. If the setup code of a connected device is not contained in the Remote Control unit memory, program the code in Remote Control unit using this function. This function can also be used to change a setup code or add extended function to the remote control target. • Up to five extended functions per device can be programmed additionally in this Remote Control unit using "Extend1" to "Extend5" displayed on the LCD screen. • The remote control signals transmitted by this Remote Control unit buttons can be changed. The signals from the buttons painted black in the following figure can be modified. + CH. CH.- + VOL. VOL.- To program new functions in Extend1 to Extend5: 1. Select the controlled device (CD, DVD, etc.) by pressing the MUSIC, MOVIE oRrECTV button. Video1 DVD FFFFFFMenu 2. Press the LEARN button. REC + + - - Extend1 Extend2 Extend3 HomeFFEnter /8 1 /7 1 1 2 3 4 5 6 7 8 9 +10 0 +100 10 11 12 3. Select one of Extend1 to Extend5 using the or button, then press the Enter button (LCD function but- ton 2). Waiting Extend1 ClrFFExit