Kenwood VR-5700 User Manual 1 - Page 56

Chapter Five : Warnings and Specifications Chapter Five: Warnings and Specifications Read this page carefully to ensure safe operation. Warnings FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications if it is not installed and used in accordance with the instructions. However, there 50 is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from the one that the receiver is connected to. • Consult the dealer or an experienced radio/TV technician for help. FCC Compliance Notice Audio-video Receiver, VR-5700, VR-5090 and VR-5080, and Remote Controller, RC-R0913 These devices comply with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. KENWOOD U.S.A. CORPORATION 2201 East Dominguez St., Long Beach, CA 90801-5745 Telephone: 310-639-9000 IC(Industry Canada) Notice Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Note to CATV System Installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. NOTE: Do not use contact cleaning agents because they could cause a malfunction. Be especially careful not to use contact cleaning agents containing oil, since they may deform the plastic components. Kenwood follows a policy of continuous advancements in development. For this reason, specifications may be changed without notice. Full performance may not be exhibited in extremely cold locations (below 0 deg. C). VR-5700 Specifications Audio Section Rated Output Power during stereo operation 120 watts per channel minimum RMS, both channels driven, at 6 Ω from 20Hz to 20kHz with no more than 0.03% total harmonic distortion (FTC). Effective Output Power during surround operation 1 kHz, 0.06% T.H.D. at 6 Ω, all channel driven (Front, Center, Surround 120 W × 5 Total Harmonic Distortion 0.005 % (1 kHz, 60 W, 6 Ω) Frequency Response (IHF'66) Line (CD1, MD/TAPE, CD2/TAPE2 MONITOR, CD-R, VIDEO 1 - 4, DVD/6CH 7 Hz ~ 100 kHz, 0 dB, -3 dB Signal to Noise Ratio (IHF '66) PHONO (MM 76 dB CD1 98 dB Input Sensitivity / Impedance PHONO (MM 4.0 mV / 47 kΩ CD1 300 mV / 47 kΩ DVD/6CH 300 mV / 47 kΩ Output Level / Impedance TAPE REC 300 mV / 2.2 k Ω PRE OUT (Front, Center, Surround, Surround back 1 V / 470 Ω PRE OUT (Subwoofer 1.8 V / 470 Ω Tone Control Bass 7 dB (at 100 Hz) Treble 7 dB (at 10 kHz) Loudness Control Volume at -30 dB level ....... +6 dB (100 Hz), +3 dB (10 kHz) Digital Audio Section Sampling Frequency 32 kHz, 44.1 kHz, 48 kHz, 96 kHz Input Level / Impedance / Wavelength Optical 15 dBm ~ -21 dBm, 660 nm +30 nm Coaxial 0.5 Vp-p / 75 Ω Output Level / Impedance / Wavelength Optical 15 dBm ~ -21 dBm, 660 nm +30 nm Coaxial 0.5 Vp-p / 75 Ω Specifications