Kenwood VRS-7200 Instruction Manual - Page 12

Setting up the system Connecting the speakers CAUTION Make sure that the power cord plug is disconnected from the AC wall outlet before proceeding to speaker cord connections. If the conductor wires on the extremity of speaker cord are untwisted, there is a risk of short-circuiting. Be sure to twist them well before connecting the speaker cord. Front Speakers Whether each speaker is connected properly can be confirmed by outputting the test tone and checking if each speaker channel outputs audio. For details, see "Speaker settings" (Step 6 Adjust the speaker volume level). ) Protection circuitry This unit incorporates protection circuitry, which may be activated during high-power reproduction or in case of extreme rise in temperature. When the protection circuitry is activated, the output from this unit is shut down and the STANDBY indicator blinks. In this case, turn this unit OFF then ON again and reduce the output volume level. Right Surround Speakers Left Be sure to connect both surround speakers Center Speaker Right Surround Back Speaker When the surround back speaker is connected to these terminals, set the speaker setting to "BS/SW BS". ) In this case, the subwoofer should Left be connected to the PRE OUT SUBWOOFER jack. $ Subwoofer When the subwoofer is connected to these terminals, set the speaker setting to "BS/SW SW". ) In this case, two surround back speakers should be connected to the PRE OUT SURROUND BACK jacks. $ 12 EN L CENTER R SURR L FRONT R SURR BACK / SW SPEAKERS (6-8Ω)