KitchenAid KBSD702MPS Owners Manual - Page 23
Install Overlay Series Custom Panels, Door Panel Installation
View all KitchenAid KBSD702MPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
3. Continue adjusting all of the leveling legs to raise the refrigerator until the top is within at least 1" (2.54 cm) of the top soffit. NOTE: If an anti-tip board has been used, adjust the leveling legs until the top of the refrigerator is within ¹⁄₄" (6.35 mm) of the bottom of the anti-tip board as shown. Do not crush the compressor cover. 3. Remove the handle-side and top trims. A B C 2" (5 cm) D A. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards B. Attach to studs with six #8 x 3" (7.6 cm) screws. C. Compressor cover D. Distance from bottom of anti-tip board to floor 4. After leveling the refrigerator, again use a straight edge or 4 ft level across the front of the refrigerator installation blocks to the cabinets to check that the refrigerator is still flush. Install Overlay Series Custom Panels IMPORTANT: � Install the custom handles prior to installing the panels on the refrigerator. For more information on KitchenAid custom handle selection, refer to the KitchenAid Catalog, visit www. kitchenaid.com, or call 1-800-442-9991. In Canada, visit www.KitchenAid.ca, or call 1-800-807-6777. � Create custom door overlay panels according to the specifications in the "Overlay Series Custom Panels" section. � KitchenAid is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service. Door Panel Installation 1. Remove all tape and door bracing from the refrigerator and freezer doors. 2. Open the refrigerator and freezer compartment doors. A. Trims 4. Slide the custom panels into the bottom and hinge side trims on the refrigerator compartment and freezer compartment doors, making sure that the backer panel fits into the hinge side trims. A. Panels 5. Reinstall the handle-side and top trims. 6. Remove the skin from the screw covers. Slide or snap the screw covers into the handle trim section. 7. Check refrigerator level and alignment. Adjust if needed. 23