Konica Minolta bizhub C550 LK-101/LK-102 License Authentication Operation Guid - Page 45

Repair After replacement of the parts, the message "License Management Error occurred" may be displayed on the control panel. When it the message appear, it is necessary to perform repair operation. ¾ The repair operation can be done with accessing LMS. When those parts as listed below is replaced, the message "License Management Error " may be displayed. ¾ When replacing those parts below, please replace it with new parts. When the parts are replaced with used parts, the message condition can not be solved by performing the repair operation. — NVRAM — Service EEPROM Board ¾ If License Activation Base function was already activated z While the error message is indicated on the control panel, the License Activation Base Function will not be disabled. z When the error message is indicated after replacement of the NVRAM, License Activation is required after the completion of the repair operation to use the function again. ¾ If License Activation Base function was not activated z Even the function was not activated, the message may be indicated if those parts mentioned before is replaced. MFP can be used without the repair operation, but to solve it, the repair operation is required. Overview of Repair Operation — With accessing LMS with the web browser, it is necessary to enter the Serial number, Request Code, and Repair Request Code. Then LMS issues Repair Code. With using the Repair Code issued from LMS, the repair operation will be preformed. To perform repair operation, the code has to input in the MFP through the control panel. — Who to perform the operation — Customer engineer or sales person MFP — To access to LMS for repair operation, user ID and password is required. LMS [Serial Number] [Repair request code] [Request Code] Input [Repair Code] Repair Issued by BT-CSInOput 45 Output Ver 1.03