Kyocera FS-1800N FS-1800/3800 Installation Manual Rev 1.3 - Page 10

Parallel Interface Connection 1 Plug one end of the printer cable (not included) into the parallel interface connector on the rear of the printer. Clip Clip Parallel Printer Cable • Use a parallel printer cable that complies with the IEEE1284 standards. • The printer will work best if it is installed near the computer. The connecting cable should be shielded and not be longer than 3 meters (10 feet). 2 Close the clips on both sides to fix the connector in place. Plug the other end of the printer cable into the computer's parallel interface connector. Serial Interface Connection 1 Plug one end of the printer cable (not included) into the serial interface connector on the rear of the printer. The printer will work best if it is installed near the computer. The connecting cable should be shielded and not be longer than 3 meters (10 feet). Serial Interface Cable 2 Securely tighten the screws on both sides of the connector. Plug the other end of the printer cable into the computer's serial interface connector. 8