Kyocera KM-6030 Printing System (V) Operation Guide (Setup Edition) Rev-1 - Page 12
Installing the software, Setting the network (TCP/IP), Notes
View all Kyocera KM-6030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Set-up Installing the software Install the software such as printer driver according to your computer system. For the method of installation, refer to the Functions Edition. Setting the network (TCP/IP) When using this machine as a network printer, you must set the IP address of this machine. Notes • The IP address that should be registered here will differ depending upon your environment. Check with your network administrator BEFORE performing this setting. • If you are using a DHCP or BOOTP server to automatically configure the IP address, you will not need to change the IP address because DHCP or BOOTP server configuration is already enabled as the factory default setting. • To cancel the setting, press the [Stop/Clear] key. 1 Press the [Printer] key. The machine enters the printer mode. 2 Press [Printer Menu]. 3 Press [Interface]. 4 Press [Network]. 6 Ready to print. Printer Menu Select item. Printer menu Print Status Page Interface Emulation Font Page Set Print Quality Paper Handling RAM DISK Mode Interface Setting Item NetWare TCP/IP Ethertalk Network Status Page Value On On On Off Parallel Network USB Printer menu Cancel Others Change #