Kyocera TASKalfa 2420w TASKalfa 2420w Operation Guide - Page 20

Pre-printed Extremely slippery Extremely sticky Extremely thin and soft OHP Film CAUTION Do not use the paper with staple, or do not use such conductive paper as aluminum foil and carbon paper. The above may result in a danger of fire. NOTE (1) Print image may become light if printed on a rough surface of the paper. (2) Print image may become defective if the print paper has an excess curl. (3) It will cause paper mis-fed, poor print image or creasing if you use a paper that does not satisfy the specifications. (4) Do not use a paper of which surface is very special, such as thermal paper, art paper, aluminum foil, carbon paper or conductive paper. (5) Vellum exposed to air over a long period tends to cause a defective printing. It is recommended to remove one round on the surface of the vellum roll from the beginning. (6) Remove fully any adhesive from the roll that may remain due to tape placed by the media supplier. (7) Do not use papers with unpacked (exposed in high / low temperature & humidity) in a long period. Such papers may result in mis-feed, defective image or paper creasing. (8) It is recommended to trim the leading edge by using Initial Cut Key on the User Interface (UI) before making a long print. For trimming the leading edge, see [2.4 Initial Cut]. 1. 7. 2 Keeping the paper in the custody Keep the paper in the custody taking care of the following matters. 1. Do not expose the paper to the direct sunlight. 2. Keep the paper away from high humidity. (It must be less than 70%) 3. Put the paper on a flat place 4. If you will keep the paper in the custody, which you have already unpacked, put it into the polyethylene bag to avoid the humidity. 1-15 Chapter 1 Before Use