LG A939KBGS Owners Manual - Page 18
Attaching the Mop Pads, Adjusting the Amount of Water, WARNING
View all LG A939KBGS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
18 OPERATION • The tank can be filled from either end. • Attaching and using mop pads while they are dry may affect the cleaning performance. 3 Close the water inlet cap tightly. • If the water inlet cap is not closed properly, water may leak. 4 Attach the water tank to the mop nozzle again. • Insert the 2 tabs e at the front of the water tank into the slots f on the top of the mop nozzle. Lower the back of the water tank into place. • Press down at the center g to lock the tank in place. Attaching the Mop Pads Use the standard mop pads for general cleaning. For stubborn stains, use the heavy duty mop pads. WARNING • To avoid injury, do not attach the mop pads while the mop plates are moving. • Do not insert your hand between the rotating mop plates. Doing so may result in injury. 1 Wet both sides of the mop pads with water and squeeze out any excess water before attaching the pads. • Do not attach pads while they are dripping wet. 2 Place the mop nozzle upside down on the floor. 3 Align and attach the center of the mop pad with the center of the mop plates. • Press firmly to attach the Velcro on the mop pad to the mop plate. Attaching the mop pad upside down or improperly may affect the cleaning performance. 4 Attach the mop nozzle to the appliance. Adjusting the Amount of Water Press the Water Adjustment button at the rear of the mop nozzle to adjust the amount of water released onto the mop pad. • High Mode: Press the High Mode button a all the way down to clean ingrained dirt or supply a large amount of water. • Low Mode: Press the Low Mode button b all the way down to supply a small amount of water for cleaning wood or other flooring that can be damaged by too much water. • STOP: Press the Low Mode or High Mode button halfway to toggle back to the STOP position. This stops the supply of water so you can go over areas that are already wet. • By default, the water adjustment button is set to STOP.