LG DLEX3550W Owner's Manual - Page 13
Installation location requirements, Clearances - reviews
View all LG DLEX3550W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
13 ENGLISH Installation location requirements wWarning Read all installation instructions completely before installing and operating your dryer! It is important that you review this entire manual before installing and using your dryer. Detailed instructions concerning electrical connections, gas connections, and exhaust requirements are provided on the following pages. • A location that allows for proper exhaust installation. A gas dryer must be exhausted to the outdoors. See Venting Requirements. • A grounded electrical outlet located within 2 ft. (61 cm) of either side of the dryer. See Electrical Requirements. • A sturdy floor to support the total dryer weight of 200 lbs (90.7 kg). The combined weight of a companion appliance should also be considered. • N o other fuel-burning appliance can be installed in the same closet as a dryer. Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. This can result in longer drying times. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector. NOTE • A level floor with a maximum slope of 1 inch (2.5 cm) under entire dryer. If slope is greater than 1 inch (2.5 cm), install the Extended Dryer Feet Kit. Clothes may not tumble properly, and automatic sensor cycles may not operate correctly if dryer is not level. • For a garage installation, you will need to place the dryer at least 18 inches (46 cm) above the floor. If using a pedestal, you will need 18 inches (46 cm) to the bottom of the dryer. Clearances 14" max.* (35.6 cm) 18" min.* (45.7 cm) 14" max.* (35.6 cm) (1485".7mcimn.)* 48 in.2* (310 cm2) 1"* 30" 5"** 1"* (2.5 cm) (76.1 cm) (12.7 cm) (2.5 cm) 24 in.2* (155 cm2) 30" 5"** (76.1 cm) (12.7 cm) 3"* (7.6 cm) 0" (0 cm) 39" (98.3 cm) 3"* (7.6 cm) 1" (2.5 cm) 27" 1" (68.6 cm) (2.5 cm) 1" (2.5 cm) 27" 1" (68.6 cm) (2.5 cm) 3"* TtInhheesstfioadlelloslwaaintndgiorsenpaar(1s4.c1(8354Rip"5,"n7,m6emagcciacmnmcxo..d)*)*iminmmgeenfnsoidoerndsrsaeprecaceriesncsgo(e1m4s18(53dh4",5"7mm,o6mcaicumanemx.)*rln.)*ddebeaed(3o14cf08oorcinrnm.2tc2s*)hidlisoerdseredytefro.irnTthshisteadfo(rl7yl,ll6eocarwmth)iinaosgnbreeaesnotness:ted for (s0p0c"mac) ing of 0 inches (0 cm) clearance on 39" min. • Additional spacing should be considered for ease of installation • Additional spacing should b(9e8,c3 ocmn)sidered on all sides of the dryer and servicing. to reduce noise transfer. 24 in.2* • Additional clearances might be required for wall, do(1o55r camn2)d floor moldings. iFno(7,tr63h"cc*emlo)tsoept installation, with a and bottom of the door, door minim1"um vent2i7l"ation op1"enings are(r2e,5qcmu)ired.(6L8o,6ucmve) red(2,d5 ocmo)rs 1"* 30" 5"** (2,5 cm) (76,1 cm) (12,7 cm) 1"* 30" 5"** (2,5 cm) (76,1 cm) (12,7 cm) Requisitos deventilación de with e(q2,5u1"cimva) lent(6v82,e67n"cmti)latio(2n,51"comp) enings are acceptable. lapuerta del armar•ioCompanion appliance spacing should also be considered. NOTE There other. should be Too much av1t(i34b5"l,e6mraacamxts.)i*toan,liitttlceosupldacceauarsoeu1(34t5n"h,6mdecamxmt.)*hteodmr4y8aeinkr.2e*(onroaisneyoorthtoeur cahp(pe7,a63li"cca*mhn) coet)hteor eliminate the causing paint transfer of vibration from one to damage and making even more the noise. 18" min.* (45,7 cm) (1485",7mcimn.)* (310 cm2) 0" (0 cm) 39" (98,3 cm) 1"* 30" 5"** 1"* (2,5 cm) (76,1 cm) (12,7 cm) (2,5 cm) 24 in.2* (155 cm2) 30" 5"** (76,1 cm) (12,7 cm) 3"* (7,6 cm) 1" (2,5 cm) 27" 1" (68,6 cm) (2,5 cm) 1" (2,5 cm) 27" 1" (68,6 cm) (2,5 cm)