LG DLEX7800WE Owners Manual - Page 14
Door Reversal Instructions, Swing door
View all LG DLEX7800WE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
ENGLISH Door Reversal Instructions NOTE The instructions here are for changing the door swing from a right to a left side hinge. If the door has been reversed, and it is necessary to change it back, use care when following these instructions. Some of the illustrations and the left/ right references will be reversed, and you will need to read the instructions carefully. Warning Be sure to support the weight of the door before removing the hinge screws. Swing door 1 Open the door from the side so that the hinge screws are accessible. 2 Remove the four hinge screws. While supporting the door, remove the four hinge screws, two from each hinge. Set the door aside face down on a protected surface to prevent damage to the door or the work surface. INSTALLATION 13 c. Remove the hinge cover by gently prying it up with a flat blade screwdriver, being careful not to scratch the paint. Rotate the hinge cover 180 degrees and install it on the opposite side, where the hinge was attached. 4 With the door on a protected surface, remove all screws on each side of the door and lift off the inner door frame using a flat blade screwdriver. Remove the latch hook and blank and install them on the opposite side. Inner door frame Blank Latch hook 5 Remove the 4 screws securing the hinges to the door frame. Remove the two plastic cover caps. Reinstall the hinges and cover caps on the opposite sides from which they were removed. Hinge assembly Cover cap 3 Reverse the components on the cabinet. hinge cover latch mechanism hinge latch hole cover hinge cover hinge a. Use a Phillips screwdriver to remove the two screws and the latch mechanism on the front panel of the cabinet. b. Remove the latch hole cover by gently prying it up with a flat blade screwdriver, being careful not to scratch the paint. Install the latch hole cover on the opposite side, where the latch mechanism was removed. Install the latch mechanism in the position from which you removed the latch hole cover, using the two screws removed in step a. 6 With the hinges and cover caps in the new locations, remount the inner door frame onto the outer door frame with the screws removed in step 4 above. Warning Be sure to support the weight of the door before installing the hinge screws. MFL70442605_en_190215.indd 13 2019-02-15 오후 2:38:16