LG DU-27FB32C Installation Guide - Page 12

Hook Up an Off Air Antenna Connect an over the air signal source to the TV Over the Air Antenna 1 Locate the Antenna/Cable jack on the back of the TV. 2 Connect the antenna that runs from the wall directly to this jack, according to the connection diagram shown Antenna to the right. If you have a 75 ohm RF cable, then you don't need any adapters! A 300 to 75 ohm adapter is not included with the LG TV. Antenna RF Coaxial Wire (75 ohm) RF Coaxial Wire (75 ohm) Typical TV Back Antenna Digital Cable Antenna Matrix Out Component Video Input Pr Pb R Audio L M.P.I. M.P.I. Y Video In R Audio In L S-Video In R Audio In L To get digital with only one RF antenna lead, install a signal splitter 1 If there is only one antenna lead available from the wall antenna jack, locate the Antenna/Cable and the Digital Antenna jacks on the back of the TV. Antenna Typical TV Back 2 Connect the antenna that runs from the wall directly to a 75 ohm 2-way signal splitter (not provided) according to the connection diagram shown to the right. 3 Connect the two antenna leads to the TV RF inputs: Antenna/Cable and Digital Antenna. This will provide the same over the air signal to both the analog and digital RF inputs. RF Coaxial Wire (75 ohm) 75 ohm Signal Splitter Antenna Digital Cable Antenna Matrix Out Component Video Input Pr Pb R Audio L M.P.I. M.P.I. Y Video In R Audio In L S-Video In R Audio In L Mini Glossary 2-Way Splitter A device that provides two antenna signals from one antenna lead. 75 ohm RF Cable The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking through the middle, and it screws onto the threaded jack on the back of the TV. 300 to 75 ohm Adapter (Not shown) A small device that connects a flat two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end. Page 12