LG HBLG2350E Service Manual - Page 15

3.6 CABINET INSTALLATION 1. Open the window. Mark a line on the center of the window stool between the side window stop moldings. Loosely attach the sill bracket to the support bracket using the carriage bolt and the lock nut. Sill Bracket Carriage Bolt (M-Screw) Figure 22 Support Bracket Lock nut 2. Attach the sill bracket to the window sill using the screws (Type B). Carefully place the cabinet on the window stool and align the center mark on the bottom front with the center line marked window stool. 3. Using the M-screw and the lock nut, attach the support bracket to the cabinet track hole. Use the first track hole after the sill bracket on the outer edge of the window sill. Tighten the carriage bolt and the lock nut. Be sure the cabinet slants outward. CAUTION: Do not drill a hole in the bottom pan. The unit is designed to operate with approximately 1/2" of water in bottom pan. Cabinet Track hole Support Bracket Carriage bolt and lock nut Figure 23 Top retainer bar Figure 24 Machine screw (Type D) and lock nut Outer edge of window sill Screw(Type B) Sill bracket Window stool Front angle 4. Pull the bottom window sash down behind the Top retainer bar until they meet. NOTE: 1. Do not pull the window sash down so tightly that the movement of Frame curtain is restricted. Attach the cabinet to the window stool by driving the screws (Type B) through the cabinet into window stool. 2. The cabinet should be installed with a very slight tilt downward toward the outside. Window sash Top retainer bar Foam-PE Cabinet Frame curtain Foam-PE Figure 25 Sash track Figure 26 Front Angle Screw(Type B) Copyright ©2007 LG Electronics. Inc. All right reserved. Only for training and service purposes - 15 - LGE Internal Use Only