LG HECTO Additional Link - Installation Manual - Page 5

Installation - laser

Get LG HECTO PDF manuals and user guides View all LG HECTO manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

INSTALLATION 5 INSTALLATION How to fix anchors and screws CAUTION yyCheck the wall materials and the thickness of finishing materials. yyYou can use the anchors and bolts provided with the Laser Display set for walls made from concrete, lightweight concrete, soft fieldstone, hard fieldstone, brick or cellular blocks. yyWhen installing it on a wall not specified in this manual, make sure each fixing point withstands an uplifting load of 70 kgf (686 N) and a shearing load of 100 kgf (980 N) or more. (Attach a plate such as plywood to strengthen the wall before installation.) a. At each anchor position, use a 8 mm drill bit to make a hole with a depth of 80 mm - 100 mm. b. Clean the holes. c. Insert the anchors provided into each hole. (Use a hammer when inserting the anchor.) d. Fix a part in place by aligning it with the screw hole. Tighten the screw with a torque 45 kgf/cm - 60 kgf/cm or higher. a b Drilling hole Anchor c Cleaning hole Inserting anchor Fixing ring and space steel d Screw for fixing ring and space steel Screw for fixing ring and space steel

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
5
INSTALLATION
INSTALLATION
How to fix anchors and screws
CAUTION
y
Check the wall materials and the thickness of finishing materials.
y
You can use the anchors and bolts provided with the Laser Display set for walls
made from concrete, lightweight concrete, soft fieldstone, hard fieldstone, brick
or cellular blocks.
y
When installing it on a wall not specified in this manual, make sure each fixing
point withstands an uplifting load of 70 kgf (686 N) and a shearing load of 100
kgf (980 N) or more.
(Attach a plate such as plywood to strengthen the wall before installation.)
a. At each anchor position, use a 8 mm drill bit to make a hole with a depth of
80 mm - 100 mm.
b. Clean the holes.
c. Insert the anchors provided into each hole.
(Use a hammer when inserting the anchor.)
d. Fix a part in place by aligning it with the screw hole.
Tighten the screw with a torque 45 kgf/cm - 60 kgf/cm or higher.
a
b
c
d
Anchor
Fixing ring and space steel
Drilling hole
Cleaning hole
Inserting anchor
Screw for fixing ring and
space steel
Screw for fixing ring and space steel