LG LRG30355SB Owner's Manual (English) - Page 36

Burner Caps And Heads

Get LG LRG30355SB - 30in Gas Range PDF manuals and user guides
UPC - 048231315876
View all LG LRG30355SB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

CARE AND CLEANING OF THE RANGE BURNER CAPS AND HEADS BURNER CAPS Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles. Burner cap is properly seated. Burner cap is NOT properly seated. BURNER HEADS For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire twist-tie works well to unclog it. The slits in the burner heads must be kept clean at all times for an even, unhampered flame. Clogged or dirty burner ports or electrodes will not allow the burner to operate properly. Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged. You should clean the burner caps and heads routinely, especially after bad spillovers which could clog the openings. Lift off when cool. To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20-30 minutes. For more stubborn stains, use a toothbrush. NOTES: • Do not use steel wool or scouring powders to clean the burners. • Burners will not light if the cap is removed. AFTER CLEANING Before putting the burner caps and burner heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes. REPLACEMENT Replace burner heads and caps over the electrodes on the cooktop, in the correct locations according to their size. There are two small burner heads and caps, one medium, one large and one extra large burner head and cap. 36

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
36
BURNER CAPS AND HEADS
BURNER CAPS
Lift off when cool.
Wash burner caps
in hot, soapy
water and rinse
with clean water.
You may scour
with a plastic
scouring pad to
remove burned-on
food particles.
CARE AND CLEANING OF THE RANGE
Burner cap is properly seated.
Burner cap is NOT
properly seated.
BURNER HEADS
For proper ignition, make
sure the small hole in the
section that fits over the
electrode is kept open.
A sewing needle or wire
twist-tie works well to
unclog it.
The slits in the burner
heads must be kept clean
at all times for an even,
unhampered flame.
Clogged or dirty burner ports
or electrodes will not allow the burner to
operate properly.
Any spill on or around an electrode must be carefully
cleaned. Take care to not hit an electrode with
anything hard or it could be damaged.
You should clean the burner caps and heads
routinely, especially after bad spillovers which could
clog the openings. Lift off when cool.
To remove burned-on food, soak the burner heads in
a solution of mild liquid detergent and hot water for
20–30 minutes. For more stubborn stains, use a
toothbrush.
NOTES:
•
Do not use steel wool or scouring powders to clean
the burners.
•
Burners will not light if the cap is removed.
AFTER CLEANING
Before putting the burner caps and burner heads
back, shake out excess water and then dry them
thoroughly by setting in a warm oven for 30 minutes.
REPLACEMENT
Replace burner heads and caps over the electrodes
on the cooktop, in the correct locations according to
their size. There are two small burner heads and
caps, one medium, one large and one extra large
burner head and cap.