LG MVEM1825F INSTALLATION - Page 12
Step 5: Install the Mounting Plate
View all LG MVEM1825F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
us_main.book.book Page 12 Wednesday, May 4, 2022 1:09 PM 12 INSTALLATION the printed trim lines, as long as you are able to align the centerline correctly. Align the centerline of the upper cabinet template with the centerline of the rear wall template, then securely tape or tack the upper cabinet template in place. Align filler blocks b over the two openings in the top of the microwave oven cabinet and attach to the cabinet with masking tape. WARNING • To avoid risk of personal injury, electric shock or death: - Note where electrical outlets and electrical wires are before you drill into the wall. - Locate and disconnect power to any electrical circuits that could be affected by installing this oven. • To avoid risk of personal injury, electric shock or death, cover the edge of the power supply cord hole with the power supply cord bushing. Drill Holes in Wall and Cabinet 1 Drill holes on the circles. If there is a stud, drill a 3/16" hole for lag screws. If there is no stud, drill a 3/4" hole for toggle bolts. Make sure to use at least 1 lag screw in a stud, and 2 toggle screws in the drywall or the plaster. 2 Drill a 3/8" hole at points J and K on the upper cabinet template. If the bottom of the upper cabinet is recessed 3/4" or more, you will need 2"x 2" filler blocks b (not included) to provide additional support for the bolts. a Cabinet front c Cabinet bottom shelf Mark the center of each filler block and drill a 3/8" diameter hole at the marks. 3 Cut or drill a 2" diameter hole at the area marked "M power supply cord hole" on the upper cabinet template. If the upper cabinet is metal, you will need to cover the edge of the hole with the power supply cord bushing (supplied) to prevent damage to the cord from the rough metal edge. 4 Cut out the venting areas (with the saber saw) • Roof-venting: cut out the shaded area marked L on the upper cabinet template. • Wall-venting: cut out the shaded area marked F on the rear wall template. • Room-venting: go to Step 5: Install the Mounting Plate. 5 Complete whichever venting system you have chosen. Use caulking compound to seal the exterior wall or roof opening around the wall cap or roof cap. Step 5: Install the Mounting Plate The oven must be connected to at least one wall stud. 1 Center the rear wall template in the space by lining up the plumb line on the wall with the centerline on the template. Then securely tape or tack the rear wall template in place. Make sure the minimum width is 30 inches and that the top of the rear wall template is located a minimum of 30 inches above the cooking surface. NOTE • If the cabinets are not plumb, adjust the rear wall template to the cabinets. If the front edge of the cabinet is lower than the back edge, adjust the template to be level with the cabinet front.