LG SWWE50N3 Owners Manual - Page 56

en-us_main.book.book Page 55 Monday, February 20, 2023 2:02 PM ENGLISH TROUBLESHOOTING 55 Problem Water supply Drainage Unbalance No water detected Motor error Water too high Freeze error No temp detected Vibration sensor Turbidity sensor Power failure Oversudsing Possible Cause & Solution Water supply pressure to faucet or house is too low. • Check another faucet in the house to make sure that household water pressure is adequate and flow is not restricted. • Disconnect the water inlet hoses from the washer and run a few gallons of water through the hoses to flush out any dirt. • If flow is too low, contact a plumber to have the water supply lines repaired. Water supply connected with leak-limiting hoses. • The use of hoses designed to limit leaks is not recommended. Leak limiting hoses can trip falsely and prevent the washer from filling. Drain hose is kinked, pinched, or clogged. • Make sure that the drain hose is free of clogs or kinks and is not pinched behind or under the washer. The end of the drain hose is more than 96 inches (2.4 m) above the bottom of the washer. • Move the end of the drain hose so that it is lower than 96 inches (2.4 m). For best performance, the end of the drain hose should be no higher than 66 inches (168 cm). The load is too small. • Add additional items to allow the washer to balance the load. Heavy articles are mixed with lighter items. • Always try to wash articles of somewhat similar weight to allow the washer to evenly distribute the weight of the load for spinning. The load is out of balance. • Manually redistribute the load if articles have become tangled, preventing the automatic rebalancing from working properly. The water level sensor is not working correctly. • Close the water faucets, unplug the washer, and call for service. A motor error has occurred. • Allow the washer to stand for 30 minutes and then restart the cycle. • If the error code is still displayed, call for service. Water level is too high due to a faulty water valve. • Close the water faucets, unplug the washer, and call for service. Inlet hose, drain hose or drain pump is frozen. • See Care in Cold Climates. Control error. • Unplug the washer and wait 60 minutes. Reconnect power and try again. • If the error code is still displayed, call for service. Vibration sensor is malfunctioning. • Call for service. Turbidity sensor is malfunctioning. • Call for service. There was a power interruption or the power cord was not properly plugged in. • Plug in the power cord or press the Start/Pause button to restart the cycle. Too much detergent was used. • Do not add more than the recommended amount of detergent.