LG WM3555HWA Owners Manual - Page 10

us_main.book.book Page 10 Tuesday, October 12, 2021 1:56 PM 10 INSTALLATION WARNING • Certain internal parts are intentionally not grounded and may present a risk of electric shock only during servicing. Service personnel- Do not contact the following parts while the appliance is energized: pump, valve, motor, control board. Tools Needed • It is the personal responsibility and obligation of the washer owner to have a proper outlet installed by a qualified electrician. a Pliers b Flat-Blade Screwdriver c Level Choosing the Proper Location Check the following requirements for the install location before installing the washer. • Allow for sufficient space between the walls and the washer for installation. • Make sure that the floor is clean, dry and free of dust, dirt, water and oil so the leveling feet cannot slide easily. Leveling feet that can move or slide on the floor can contribute to excess vibration and noise. • If the floor has too much flex, reinforce it to make it more rigid. If the floor is not solid, it may cause severe vibration and noise. • If a drain pan must be used, take extra care to follow the instructions provided with the drain pan and make sure the leveling feet are adjusted for firm and even contact with the pan. Use of drain pans and failure to properly level the washer may result in increased vibration and noise during operation. Power Outlet • The power outlet must be within 60 inches (1.5 m) of either side of the washer. • Position the washer so that the outlet and plug are easily accessible. • Do not overload the outlet with more than one appliance. • The outlet must be grounded in accordance with current electrical wiring codes and regulations. • Use a time-delay fuse or circuit breaker. Flooring • To minimize noise and vibration, install the washer on a level, solidly constructed floor capable of supporting the washer without flexing or bouncing. • The washer must be installed on firm flooring to minimize vibration during the spin cycle. Concrete flooring is best, but a wood floor is sufficient, provided it is built to FHA standards. • The floor under the washer must not slope more than 1 inch (2.5 cm) from front to back or side to side. • Installing on carpeting and soft tile surfaces is not recommended. • Never install the washer on a platform or weakly supported structure. Floor Installation To ensure sufficient clearance for water inlet hoses, drain hose and airflow, allow minimum clearances of at least 1 inch (2.5 cm) at the sides and 4 inches (10 cm) behind the washer. Be sure to allow for wall, door, or floor moldings that may increase the required clearances. A G C B DE F E Dimensions and Clearances A 21'' (53 cm) B 43 1/4'' (110 cm) C 22 1/4'' (56.5 cm) D 4'' (10 cm) E 1'' (2.5 cm)