Lenovo J115 Hardware Maintenance Manual - Page 96
Replacing the diskette drive
View all Lenovo J115 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
4. Slide the drive being replaced out the front of the computer. 5. If the drive you are replacing has jumpers on the rear, make sure the jumpers on the new drive are in the same exact position as the drive being replaced. 6. Slide the new drive into the bay until the screws holes on each side are aligned and install two screws in each side of the drive. 7. Reconnect the power cable and signal cable to the new optical drive. 8. Go to "Completing the FRU replacement" on page 92. Replacing the diskette drive 1. Remove the left-side and right-side covers. See "Removing the covers" on page 70. 2. Disconnect the signal and power cables from the rear of the hard disk drive. Note: You will probably have to disconnect cables that are connected to the system board and other drives to allow the diskette drive to be removed from inside the chassis. 3. Remove the two screws that secure the drive on each side. 90 Hardware Maintenance Manual Lenovo 3000 J Series