Lenovo ThinkCentre A61 Hardware Maintenance Manual - Page 139
replacement
View all Lenovo ThinkCentre A61 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
6. Install the new hard disk drive into the blue bracket, flex the bracket, and align the pin 1 , pin 2 , pin 3 , and pin 4 on the bracket with the holes in the hard disk drive. Do not touch the circuit board 5 on the bottom of the hard disk drive. 7. Connect the signal and power cables to the rear of the hard disk drive. 8. Position the hard disk drive and bracket so that it engages the retaining clips in the bottom of the chassis when you slide the bracket to the right. 9. Slide the hard disk drive and bracket to the right until it snaps into position. 10. Align the drive bay assembly studs with the two slots on each side of the chassis and reconnect the diskette drive and optical drive cables (if disconnected). 11. Slide the drive bay assembly towards the rear of the chassis until it snaps into position. 12. Reinstall the front bezel. 13. Go to "Completing the FRU replacement" on page 140. Chapter 9. Replacing FRUs - Desktop computers 133