Lexmark 3000 Color Jetprinter Service Manual - Page 41
System Board Removal, Repair Information 4-11
View all Lexmark 3000 Color Jetprinter manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
System Board Removal 1. Remove the front cover. 2. Remove the rear cover. 3. Unlock the four printhead cable connectors and disconnect the printhead cables from the system board. 4. Disconnect the other cables from the system board. 5. Remove the three screws securing the system board to the carrier frame and remove the system board. Note the routing of all the cables. 6. Remove the system board being careful not to damage the Endof-Form flag. 7. Set NVRAM to the proper country defaults. See "NVRAM Defaults" on page 3-3. Repair Information 4-11
Repair Information 4-11
System Board Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Unlock the four printhead cable connectors and disconnect the
printhead cables from the system board.
4. Disconnect the other cables from the system board.
5. Remove the three screws securing the system board to the
carrier frame and remove the system board. Note the routing of
all the cables.
6. Remove the system board being careful not to damage the End-
of-Form flag.
7. Set NVRAM to the proper country defaults. See "NVRAM
Defaults" on page 3-3.