Lexmark 4600 T64x - Setup Guide - Page 37
Installing printer memory or option cards, Accessing the printer system board
View all Lexmark 4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
8 Installing printer memory or option cards CAUTION: If you are installing memory or option cards sometime after setting up the printer, turn the printer off, and unplug the power cord from the wall outlet before continuing. After installing memory or option cards, go to Scanner setup on page 42. The instructions in this section help you install the interface card, memory card, and firmware card. Information about other memory or option cards can be found in the printer User's Guide. Accessing the printer system board You must access the printer system board to install the interface card, memory card, and firmware card. Note: Use a Phillips screwdriver to remove the system board access cover. 1 Push the release latch, and lower the multipurpose feeder. 2 Push the release latch, and open the top front cover. 3 Press both side door latches, and open the side door. 4 Loosen, but do not remove, the six screws on the shield. Installing printer memory or option cards 36