Lexmark Optra T614 Administrator's Guide (1.4 MB) - Page 126
Replacing the fuserassembly, Open the rear access door and remove the redrive.
View all Lexmark Optra T614 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Replacing the fuser assembly CAUTION: The fuser assembly is hot! Turn the printer off and wait twenty minutes before changing the fuser assembly. NOTE: For best results, use Lexmark supplies with the printer. If you are in the U.S. or Canada, call 1-800-438-2468 for information about Lexmark Authorized Supplies Dealers in your area. In other countries, contact the place where you bought your printer. You should order a new fuser assembly when toner fog or background shading appears on printed pages. See page 129 for ordering a fuser assembly. Complete the following steps to replace the fuser assembly. Refer to the documentation that comes with the fuser assembly for detailed installation information. 1 Turn the printer off, unplug the printer power cord, and wait twenty minutes. 2 Remove the top cover and all installed output options. If you have a duplex unit remove the printer from the duplex unit. 3 Remove the fuser cover. (If you have a label printer, lift up and remove the fuser cleaner.) 4 Open the rear access door and remove the redrive. 5 Remove the old fuser assembly. 6 Install the new fuser assembly and replace the redrive. 7 Close the rear access door and replace the fuser cover if necessary. 8 If you have a duplex unit, reinstall the printer on it. Reinstall all output options and the top cover. 9 Plug the printer power cord into a properly grounded electrical outlet and turn the printer on. Maintaining Your Printer 126